This Plug n' Play harness will allow you to use a 3rd generation 4 pin hub in a vehicle that was originally equipped with a 1st generation 12 pin hub (two rows of 6 pins).
- Plug n' Play - No cutting or splicing.
- Must be equipped with MyFord Touch and listed below under "GEN 1" - Verify connector in picture matches your vehicle.
|Vehicle||GEN 1||GEN 2a||GEN 2b|
Videos Hide Videos Show Videos
14 Reviews Hide Reviews Show Reviews
Completely plug and play and the only alternative to this cable for a Sync 2 upgrade involves splicing and soldering in a factory cable (in the cramped confines of your car cabin no less). Worth buying unless you are very comfortable with wiring work and soldering. This is the only part I bought from 4dtech for my upgrade.
As advertised, prefect fit, does the job, looks good doing it.
These adapters work great it is just plug and play. It could not be any easier and it works with out have to splice any wires and run the risk of causing other problems with the wiring on you automobile especially since the wiring on the newer cars is so small.
This connector makes installing the Sync 3 hub truly plug and play. No soldering, cutting, or rewiring. Sure it costs more, but it saves time and a professional look.
If you have looked at the harness you have to deal with, you see this expensive cable as a bargain.
Excellent adapter, worked as described, super fast shipping.
Instead of hacking up your stock harness to pin it to the media hub, this makes it an easily plug-and-play. I used it for my 2016 F-350. $50 seems a bit much, but this was the easiest/fastest option to buy at the time.
Gets the job done 100% plug and play. It's not exactly cheap but money well spent. You can do the install of your upgrade in 20 minutes start to finish with this.
Worked great plug and play super fast shipping just a perfect fit and transaction. These people have got great service and lots of helpful videos to be sure you get the right part.