Product details
How it works
The device remembers your Start / Stop preference between drives. Use the factory Start / Stop button to change your selection.
Factory remote start continues to work with the Start / Stop Eliminator installed.
Check your fitment
- 2021, 2022, 2023 & 2024 Genesis GV80
Installation
- Open the drivers side door, and remove the crash pad side cover using a plastic dash removal tool. Unplug the connector that plugs into the back of the Start / Stop Switch assembly (silver switches left of the steering wheel). Although not required, you can remove the lower panel for better access. Install Start / Stop Eliminator between the two factory connectors.

A paper quick-start guide is included. For help with your installation, contact our support team.
Designed by 4D Tech.
Supported by 4D Tech.
We design the circuit board, firmware and wiring harness for our Start / Stop Eliminators. Your purchase includes installation guidance and support directly from the designers.
Designed and supported in the USA. Meet 4D Tech.
Warranty information
One year from date of purchase6 Reviews Hide Reviews Show Reviews
-
Start/stop eliminator
This product met all my expectations. super simple to install and it came quickly to my house. Best part of it all, made in the United States. The only thing I would like to mention is it says you can reach the switch with removing only one panel. I found that wasn't the case with my Genesis GV80. I had to remove the side panel, the panel under the steering wheel and then remove the switch panel. But other than that, it was three screws, super simple. Love It, would buy it again.
-
2021 Genesis GV80
Very good product. So glad it came with instructions, and it was easy to install. Wife is super happy.
-
Start/Stop GV80
The online instructions to install this device on my 2023 GV80 were excellent and easy to execute.
-
Installation issues
Although the product seems to be working as advertised, the installation instructions are not accurate at all for a 2024 GV80. The instructions state to remove a panel to install. It states you can remove a second panel for better access. In reality you have to remove 3 panels and loosen another in order to feed the plug through a very small access point to be able to plug it into the switch. I tried to follow the instructions but there was no way to access the small area behind the switch without more steps. The area is quite restrictive. All instructions should be written only after one has completed an installation.
-
GV80 Start/Stop
Works great and was easy to install
-
Start/Stop eliminator
Unit works great, but was rather intensive to install. The dash needed to be pulled apart further than the instructions to allow access to the switch.