Product details
Start each drive with Start / Stop off
The 4D Tech Start / Stop Eliminator automatically turns off Auto Start / Stop each time you start your 2020–2024 Ford Explorer. Remote start is retained.
- Rear-wheel drive (RWD): Use the factory button to re-enable Start / Stop for that drive. The device turns it off again at the next startup.
- All-wheel drive / four-wheel drive (AWD/4WD): Remove the device and reconnect the original harness to restore factory Start / Stop operation.
Check your fitment
Fits 2020–2024 Ford Explorer with factory Auto Start / Stop, across trim levels and screen orientations. Not compatible with hybrid models.
Find the connection before ordering
The device connects inline at the black gateway module above the brake-pedal area—not the diagnostic port. No tools or trim removal are required, but the connector is tucked up inside the dash and access is tight. Watch the video and locate the connection before purchasing.
Watch the complete 2020–2024 Explorer installation video.
The module is shown outside the vehicle to identify its shape and release tab. You do not need to remove the module for this installation.
- Locate the gateway module. From beneath the driver-side dash, locate the diagnostic port as a reference only. Follow the opening behind it, to the left of the brake pedal, then look above the brake-pedal switch with the light-blue connector shown in the video. The gateway connector faces toward the front of the vehicle.
- Release the factory connector. Find the release tab on the bottom center of the connector. Push the connector inward slightly, firmly press the release tab, then gently wiggle and pull the connector housing out. Do not pull on the wires.
- Connect the Eliminator inline. Connect the factory plug to the matching Eliminator connector, then connect the other end to the gateway module. Make sure both connections are fully seated.
- Check operation. Start the vehicle. The device applies the OFF setting automatically; the video shows the button light and instrument-cluster confirmation.
A paper quick-start guide is included. Contact our support team if you need help identifying or reaching the connector.
Designed by 4D Tech.
Supported by 4D Tech.
We design the circuit board, firmware and wiring harness for our Start / Stop Eliminators. Your purchase includes vehicle-specific installation guidance and support directly from the designers.
Designed and supported in the USA. Meet 4D Tech.
Warranty information
One year from date of purchase53 Reviews Hide Reviews Show Reviews
-
Works as described.
Works as described. Instructions were wrong but was able to find a youtube video that worked.
-
Start Stop Eliminater
Works perfect, Easy to install, Love it.
-
Start/Stop Eliminator
This product worked as advertised in our 2020 Ford Explorer.
-
Must Have!
Works perfectly in my 2021 Explorer, no more dealing with the annoying auto shutoff!
-
No more engine off!
So annoying! I can't believe that Ford installed this in the 21 Explorer! I hate it, and hate it more when the engine turns off and then back on.. What a waste of starter and battery, doesn't save any fuel here in south florida, just annoying. But thanks to these guys, the SUV will remember to keep that useless function off for good! I wish this device could also remember the drive setting. Last thing, why can't that 8" screen just turn off and stay off? Why didn't Ford put a 'screen off' button or a setting for a timer? I feel for ST folks that have to stare at that huge laptop screen molded into their dashboard.
-
Start / Stop Eliminator
I LOVE this thing works perfectly - I will recommend this to everyone. I installed it in less that 5 min.
-
Start Stop Eliminator
My wife has a 2020 Ford Explorer XLT with the Auto Stop on it . It is very inconvenient and worried it will wear out the starter. Your Product solved the problem. Thank you
-
Amazing little gadget!
The start stop eliminator brought sanity back to my life! It took less then five minutes to install! Works great!