Product details
Start each drive with Start / Stop off
The 4D Tech Start / Stop Eliminator automatically turns off Auto Start / Stop each time you start your 2020–2024 Ford Explorer. Remote start is retained.
- Rear-wheel drive (RWD): Use the factory button to re-enable Start / Stop for that drive. The device turns it off again at the next startup.
- All-wheel drive / four-wheel drive (AWD/4WD): Remove the device and reconnect the original harness to restore factory Start / Stop operation.
Check your fitment
Fits 2020–2024 Ford Explorer with factory Auto Start / Stop, across trim levels and screen orientations. Not compatible with hybrid models.
Find the connection before ordering
The device connects inline at the black gateway module above the brake-pedal area—not the diagnostic port. No tools or trim removal are required, but the connector is tucked up inside the dash and access is tight. Watch the video and locate the connection before purchasing.
Watch the complete 2020–2024 Explorer installation video.
The module is shown outside the vehicle to identify its shape and release tab. You do not need to remove the module for this installation.
- Locate the gateway module. From beneath the driver-side dash, locate the diagnostic port as a reference only. Follow the opening behind it, to the left of the brake pedal, then look above the brake-pedal switch with the light-blue connector shown in the video. The gateway connector faces toward the front of the vehicle.
- Release the factory connector. Find the release tab on the bottom center of the connector. Push the connector inward slightly, firmly press the release tab, then gently wiggle and pull the connector housing out. Do not pull on the wires.
- Connect the Eliminator inline. Connect the factory plug to the matching Eliminator connector, then connect the other end to the gateway module. Make sure both connections are fully seated.
- Check operation. Start the vehicle. The device applies the OFF setting automatically; the video shows the button light and instrument-cluster confirmation.
A paper quick-start guide is included. Contact our support team if you need help identifying or reaching the connector.
Designed by 4D Tech.
Supported by 4D Tech.
We design the circuit board, firmware and wiring harness for our Start / Stop Eliminators. Your purchase includes vehicle-specific installation guidance and support directly from the designers.
Designed and supported in the USA. Meet 4D Tech.
Warranty information
One year from date of purchase53 Reviews Hide Reviews Show Reviews
-
Start stop Eliminator
Item works great. Quick install 10 to 15 minutes and no tools needed.
-
Start stop
Easy to install and works great
-
Great Product
Works as advertised. Well built & easy to install. No more annoying engine cutting off when stopped.
-
Start/stop eliminator
I tried to purchase this on Amazon (out of stock). I then called your customer service and was told I could buy direct. Fantastic service. Quick delivery. Helpful instructions (youtub video). Problem solved.
-
Auto start stop eliminator
Works as advertised and easy to install
-
Start/Stop Eliminator
This works just as described. We watched the installation video and wife installed it easily.
-
Start stop eliminator 22 explorer
It took me about nine minutes to install the eliminator. What took to most time was installing the plug, had to do it without being able to see the connection point. Still wasn' difficult to do. Well worth it to eliminate the frustration of the vehicle shutting off everytime you stopped.
-
start stop eliminator
fast shipping and product works great
-
Excellent device
Easy to install and works perfectly.