F150 (2021–2027) Start / Stop Eliminator

How it works

The 4D Tech Start / Stop Eliminator initially turns Auto Start / Stop OFF. Leave it there, or use your factory button to turn it ON. The device remembers either selection and restores it the next time you start your F-150.

Your factory button continues to work normally. Turn Start / Stop ON or OFF whenever you want; the device remembers either selection. Remote start continues to work.

Check your fitment

Fits the F-150 model years shown in the Fits section above, including Raptor. Works with either factory button location: above the touchscreen or to the left of the steering wheel, above the headlight switch.

Not compatible with PowerBoost™ Hybrid models.

Install behind the lower glovebox

No tools, wire cutting or programming are required. Watch the vehicle-specific installation video on this page before you begin.

1. Open the lower glovebox, press both sides inward to release the stops, then lower it. As shown in the video, the glovebox can be unsnapped from its hinges and set aside for access.
2. Locate the rightmost white connector in the bank of four shown in the diagram. Press its release tab, which faces toward the driver's side, and unplug it.
3. Connect the Start / Stop Eliminator inline between the factory connector and its original connection point. Push both connections fully into place until each audibly clicks.
4. Tuck the device and wiring out of the glovebox's path. Refit the glovebox on its three hinges and close it, checking that the wiring does not interfere.

Use the diagrams to identify the location and the video to see the complete connection procedure. Diagram colors are highlights; identify the connector by position, not color alone.

The same installation connection is used across all supported F-150 versions, including Raptor.

A paper quick-start guide is also included. If you need help, contact our support team.

One-year device warranty  ·  Shipping  ·  Returns