Product details
Your preferred setting, every drive
The 4D Tech Start / Stop Eliminator remembers your Auto Start / Stop setting and restores it when you start your Yukon. Choose OFF to keep the engine running at stops, or choose ON to use the factory system. Your factory button continues to work normally, and remote start is retained.
Check your fitment
Fits the GMC Yukon and Yukon XL model years shown in the Fits section above, including Denali. Choose the installation video for your model year before beginning; the dashboard layout and access procedure differ.
Choose your installation guide
2021–2024: Watch the 2021–2024 installation video. The illustrations below show this dashboard.
2025–2026: Watch the 2025–2026 installation video. Use this guide for the newer dashboard; do not follow the older trim illustrations.
Tools to have ready
- Plastic trim-removal tools
- 7 mm nut driver
- Small flat-blade screwdriver
Watch your model-year video for the access steps and tools used. No Torx driver is required.
Installation overview
- Access the switch panel. Follow the video for your model year to remove the surrounding trim and reach the factory connection.
- Connect inline. Disconnect the factory plug from the switch panel and connect the Start / Stop Eliminator between them, following the video.
- Reassemble and check operation. Follow the video to position the wiring and reinstall the trim. Use your factory Start / Stop button to select your preferred setting.
Seat the cam-lock connector before closing the lever. Start with the lever fully open. Press the connector squarely into its mating socket until the lever moves at least 45 degrees on its own, then use the lever to draw it in the rest of the way. If it will not seat, stop and check alignment rather than forcing it or swapping lock handles.
A paper quick-start guide is included. If you need help identifying the connection or releasing a connector, contact our support team.
2021–2024 installation illustrations
Designed by 4D Tech.
Supported by 4D Tech.
We design the circuit board, firmware and wiring harness for our Start / Stop Eliminators. Your purchase includes vehicle-specific installation guidance and support directly from the designers.
Designed and supported in the USA. Meet 4D Tech.
Warranty information
One year from date of purchase13 Reviews Hide Reviews Show Reviews
-
Thank you
My tools showed up today and I installed my switch. Thank you so much for creating a product to disable that thing, and for being so responsive!
-
Easy install and worked on a 23 Yukon
Easy install. Even easier than what the video shows. All you need to do is pop the bottom panel out and the side panel out and then there is one screw on the sign that holds in the panel where the start stop in the other items are located at. Once that's unscrewed, just pop that panel out. Also, I noticed that upon start up, it doesn't necessarily remember his last day until about 5 to 10 seconds and then it remembers its last state whether it was on or off. I saw this on a 2023 Yukon Denali ultimate with the 3.0 L Duramax diesel
-
Quick delivery, easy install and works great.
Quick delivery, easy install and works great
-
Stop switch
Easy install
