Product details
How it works
The device automatically turns Auto Start / Stop off at each startup. You can use the factory Start / Stop button to re-enable the system for the current drive.
Factory remote start continues to work with the Start / Stop Eliminator installed.
Check your fitment
- 2025, 2026 & 2027 Nissan Frontier.
Installation
- Remove the lower trim panel to access the two screws securing the mid climate panel. Remove the upper "Frontier" trim panel above the mid climate panel. Remove mid climate panel and disconnect the connector at the back of the Start / Stop switch. Install inline with the factory Start / Stop Off Switch and the power point.
- NOTE: The ENGINE Start / Stop switch uses the same electrical connector and is in close proximity to the AUTO OFF switch. DO NOT CONFUSE THESE TWO SWITCHES. Our product plugs in line with the AUTO OFF switch.

A paper quick-start guide is included. For help with your installation, contact our support team.
Designed by 4D Tech.
Supported by 4D Tech.
We design the circuit board, firmware and wiring harness for our Start / Stop Eliminators. Your purchase includes installation guidance and support directly from the designers.
Designed and supported in the USA. Meet 4D Tech.
Warranty information
One year from date of purchase41 Reviews Hide Reviews Show Reviews
-
Easy Install
So glad this product was available. I really don't like the start/stop, and this did the trick with easy-to-follow installation instructions.
-
Frontier (25-26) start / stop eliminator
Easy installation (10 minutes). Works as described. Don't have to think about pushing the on/off button every time you start the vehicle.
-
Start / stop
This was so easy to install using the dash removed tools are a much to have! hooking up everything was plug in play and done! put everything bavk together the job is done and works great. Thank you 4DTech you guys rock.
-
Frontier start stop eliminator
Easy install. Be sure have the special tool used in the instructional video.
-
Thank you!
Finally, Auto Start/Stop stays OFF unless I decide to turn it ON. Installation was simple and there’s not even a hint it’s there. Honestly, this should come with every new Frontier.
-
Told me what needed to be done know
It was easy to put in watching the video
-
start/stop eliminator
I watched the install video on youtube several times before I ordered the product. I then purchased one for my 2025 Frontier and another for my father in law and his 2026 Frontier. Install was fairly simple and I the fact that you don't have to push button every time after engine start up is wonderful. I referred a friend to this product and he purchased and installed on a 2021 Tahoe.
-
I live this product!
I bought this for my new Frontier and one for my new Rogue. The Rogue unit was 3 minutes install. My Frontier took a while 5 minutes because I had to remove a couple of panels. Very simple. 2 screws and a small plastic trim tool. Unplug 2 harnesses, plug this in between and put the panels back. DONE! Retained all functionality but now defaults to OFF. I live it. Highly recommend and I am telling everyone about them.
-
WORKS AS ADVERTISED
EASY TO INSTALL, IT WORKS AS DESCRIBED.