Product details
How it works
The device remembers your Start / Stop preference between drives. Use the factory Start / Stop button to change your selection.
Factory remote start continues to work with the Start / Stop Eliminator installed.
Check your fitment
- 2020, 2021 & 2022 Ford Escape
Not compatible with hybrid models.
Installation
- Simply insert between factory wire harness and back of diagnostic connector housing below the steering wheel (gateway module).


Tools needed
- None!
A paper quick-start guide is included. For help with your installation, contact our support team.
Designed by 4D Tech.
Supported by 4D Tech.
We design the circuit board, firmware and wiring harness for our Start / Stop Eliminators. Your purchase includes installation guidance and support directly from the designers.
Designed and supported in the USA. Meet 4D Tech.
Warranty information
One year from date of purchase31 Reviews Hide Reviews Show Reviews
-
Super easy install
This does exactly what it says it does. Very easy to install. Took about 3 min.
-
START/STOP
Super easy. Took me 1 min to plug in. No programming. Just plug it in and drive.
-
FORD ESCAPE START STOP ELIMINATOR
WOW WHAT A JOY IT IS TO DRIVE WITH OUT THE START AND STOP PROGRAM YOUR PRODUCT IS THE ANSWER TO MY PROBLEM THANK YOU
-
It's great
It was a pain to install, but not 4D fault it was ford's fault. When I got it installed it worked fine, glad I got it.
-
Ford Escape ‘22 Start / Stop Eliminator
4 Stars for difficult install on my ‘22 Escape. Technically not 4D’s fault-there is almost no clearance where Ford put the OBDII port. Tried the 4D video install method for over half hour and got nowhere trying to remove the 2 halves of the plug. New plan: The OBDII/Gateway module is held on by 2 x 8mm nuts. Got a ratcheting box end wrench and carefully removed nuts so as they didn’t fall into the abyss directly underneath to never be found again (socket doesn’t have clearance, must use wrench). Once entire port was free of the mounting bolts I could manipulate it so I could see and get at the applicable parts to separate the factory connection. Had to pry the factory wire insert plug out with screwdriver while pushing on lever shown in video (yes, mine was that stuck). That was impossible if I hadn’t removed the whole port. Lubed up the female and male ends of the 4D insert with dialectic grease and install clicked right in. Put it back together. Works good so far after difficult install.
-
Start/Stop Eliminator
Does what is says. Easy to install.
-
Start/Stop Eliminator
Love it. Easy install. No more forgetting to hit the button.
-
Works great.
Recieved part today and installed it. Works great. That engine auto off drove me crazy at stop signs and lights. Great product you have. Thanks.
-
Start/Stop Eliminator
Perfect! Stops the stop/start as advertised! (also remembers last setting)