Expedition (2025–2027) Start / Stop Eliminator

Your preferred setting, every drive

The 4D Tech Start / Stop Eliminator remembers your Auto Start / Stop setting and restores it when you start your Expedition. Choose OFF to keep the engine running at stops, or choose ON to use the factory system. Your factory button continues to work normally, and remote start is retained.

Check your fitment

Fits 2025–2027 Ford Expedition. Match your model year to this listing before ordering.

Installation under the driver’s side dash

The device plugs inline with the two factory connectors at the module under the driver’s side dash. No tools are required.

Watch the complete installation video before beginning. The connection is in a confined space, so review the camera angle and hand placement before reaching under the dash.

1. Locate both connections. Use the video to identify the correct module and its two connectors.
2. Release the connectors carefully. Follow the release demonstration in the video. Pull on the connector housings, not the wires; do not force a connection that has not released.
3. Connect the device inline. Connect the factory harnesses and the module to the matching plugs on the Start / Stop Eliminator, as shown in the video. Make sure each connection is fully seated.
4. Secure and check. Keep the device and wiring clear of the pedals and moving components. Start the vehicle and use the factory Start / Stop button to select your preferred setting.

If you cannot identify or release a connector, contact our support team before proceeding. A paper quick-start guide is included.

One-year device warranty  ·  Shipping  ·  Returns